The posttrialsignal attribute specifies that after running a trial, Inquisit should wait for a signal from an external device before moving on to the next trial.

Applies to

<trial> <likert> <openended> <namingtrial>

Syntax

Parameters

modality

One of the following values: Value Description keyboard The signal is defined as a key-press on the computer’s keyboard. com<n> The signal is defined a serial port signal, where n specifies the port number (e.g., COM1, COM2, COM3, ...). xid<n> The signal is defined as a XID protocol signal from a Cedrus Response Box on the serial port, where n specifies the port number (e.g., XID1, XID2, XID3, ...). lpt<n> The signal is defined as a parallel port signal, where n specifies the port number (e.g., LPT1, LPT2, LPT3, ...).

signal

An integer representing the numeric signal to wait for. If the modality is keyboard, this is the scancode of the key.

Remarks

This is useful for requiring a second confirmation response from subjects before proceding to the next trial, or for synchronizing Inquisit with an external device such as an EEG.

Examples

The following trial waits for a signal value of 8 on the COM1 port before advancing to the next trial:

<trial mytrial>
/ stimulusframes = [1=sometext]
/ validresponse = (57)
/ posttrialsignal = (com1, 8)
</trial>